MAGZO Magnetische Fliegengittertür | Normale Größe

Returns Policy

Please keep in mind that because all of our screen doors are custom made, we cannot offer a refund or exchange (remake) unless a product is defective.

If there is a defect in material or workmanship, something doesn’t work properly, or your product was made in the wrong size and doesn’t fit due to an error made at our production facility, we will replace or repair the same product in the same size you ordered at no cost to you for up to 90 days from the date of purchase.

Shipping

We offer fast and free shipping for orders in US.

All orders are processed within 3 to 5 business days (excluding weekends and holidays) after receiving your order confirmation email. Shipping time is within 7 working days.

Estimated delivery time is 10 to 12 business days. We mainly work with DHL, FedEx, USPS, UPS to provide shipping service for you.

How to Measure

Method 1 - Measure the Outer door frame

1. Measure the outer door frame or where you need to install the screen door, as shown in the picture, you should measure to the outermost part of the door frame.
2. Enter your measurements for the width of the outer frame and the height of the outer frame.
3. Double check the width and height of the screen door you need.

Method 2 - Measure the Inner door frame

1. Measure the inner door frame.
2. Add 2 inch to the width of the inner frame and 1 inch to the height of the inner frame that you measured, this is the width of the velcro.
3. Enter the dimensions from previous step
4. Double check the width and height of the screen door you need.

How to Install

1. Clean the door frame and wait until the cleaned areas completely dry.
   
   
2. Place the mesh flat on the floor with the loop side facing up.
   
   
3. Attach the supplied hook tape to the top and each 2 sides of the mesh.
   
   
4. Press HOOK&LOOP for a few seconds to fix them firmly. Peel off the top white backing paper firstly once you are ready to stick the mesh to your door frame.
   
   
5. Stick the mesh to the top of the door frame as shown on the picture, then peel off the rest backing paper and stick ook&loop to the frame from top to bottom.
   
   
6. You can use pushpins for extra support, wooden door frame only, but please be aware it will leave small holes.